MAINTENANCE
3. Wipe the dirt from the inside of the air
cleaner housing with a damp rag. Be
careful not to wipe any dirt into the air duct
that leads to the carburetor.
4. Place the foam filter over the paper filter
element and install the air cleaner filter.
5. Tighten the filter with the wing nut.
6. Re-install the air cleaner cover and tighten
with the wing nut.
Replace the Spark Plug
1. Disconnect the spark plug wire.
2. Remove the spark plug using a 13/16”
spark plug wrench (Honda & Lifan engines)
or a 5/8” spark plug wrench (Vanguard
engine).
Check the spark plug gap on the new plug
with a wire type feeler gauge. Correct the
gap if necessary in accordance with the
specifications called out in the Introduction
section of this manual.
3. Carefully install the spark plug by hand until
it is seated.
4. Tighten the spark plug 1/2 turn using the
applicable spark plug wrench to compress
the sealing washer.
5. Reconnect the spark plug wire.
General Maintenance
Motor
WARNING
Let the motor cool down prior to
servicing the saw.
DO NOT service the saw with the
motor running (unless stated otherwise).
Refer to the motor manual and
manufacturer for a full motor maintenance
schedule and additional motor maintenance
information
.
Disconnecting the Power to the Motor
Whenever maintenance is being conducted on
the saw, disconnect the power to the motor by
unplugging the power cord.
Inner Blade Flange
Inner Flange
The inner blade flange may be taken off the
blade shaft to clean or replace the part.
Installing the Inner Blade Flange
1. Inspect the inner blade flange for damages
and clean or replace as necessary.
2. Place the flange onto the stepped down
portion of the blade shaft and align it with
the blade shaft key.
3. Apply Loctite 262 (red) or an equivalent to
the setscrew threads.
4. Place the setscrew into the flange’s
setscrew hole and tighten the screw down
to the blade shaft key to secure the flange.
Note: Always make sure the flange is
secure prior to operating the saw
.
Removing the Inner Blade Flange
1. Remove the setscrew from the back of the
inner blade flange using an Allen wrench.
2. Remove the flange from the blade shaft.
Wheels
WARNING
•
Raise the saw to a proper
height for access when
working underneath the saw.
Use chocks to block the wheels, and fit
blocks or jacks under the frame edges
at the front and back of the
frame for additional support.
•
Always wear safety glasses
when removing retaining rings.
32
Summary of Contents for CC125BXL-EE6
Page 2: ......
Page 43: ...REFERENCES ...
