Diamond Products CC125BXL-EE6, Operator'S Manual

Page: 21 / 44

OPERATING
Fuel Valve Lever and Choke Lever
NOTE: To restart a warm engine, leave the
choke lever in the OPEN position.
3. Move the throttle lever away from the Min.
position, about 1/3 of the way toward the
MAX. position.
Throttle Lever
4. Turn the engine switch to the ON position.
Engine Switch
5. Pull the starter grip lightly until resistance is
felt, then pull briskly on the grip away from
the engine.
6. Return the starter grip gently to prevent
damage to the starter.
7. IF THE ENGINE STARTS, slowly move the
choke lever to the OPEN position as the
engine warms up.
8. Move the throttle lever to the MAX.
position.
9. IF THE ENGINE DOES NOT START,
move the choke lever to the OPEN position
and move the throttle lever to the MAX.
position. Repeat steps 5 & 6 until the
engine starts.
Stopping the Honda Engine
CAUTION
DO NOT leave the saw unattended until the
engine is off and the blade has stopped
spinning.
NOTE: to stop the engine in an emergency,
turn the engine switch to the OFF position.
Under normal conditions, use the following
procedure:
1. Move the throttle lever to the MIN. position.
2. Turn the engine switch to the OFF position.
3. Move the fuel valve lever to the OFF
position.
Starting the Vanguard Engine
Refer to the manufacturer’s engine manual as
the primary source of information regarding the
engine.
WARNING
•
DO NOT leave the saw unattended while
the engine is running.
• Always operate the saw in a well
ventilated area. Concentrated exhaust
can cause loss of consciousness and/or
death.
1. Move the fuel valve lever to the ON
position.
2. Move the choke lever to the CLOSED
position.
Choke Lever
Fuel Valve Lever
21