Diamond Products CC125BXL-EE6, Operator'S Manual

Page: 22 / 44

OPERATING
Fuel Valve Lever and Choke Lever
NOTE: To restart a warm engine, leave the
choke lever in the OPEN position.
3. Move the throttle lever to the full right,
FAST position.
Throttle Lever
4. Pull the starter grip lightly until resistance is
felt, then pull briskly on the grip away from
the engine.
5. Return the starter grip gently to prevent
damage to the starter.
6. IF THE ENGINE STARTS, slowly move the
choke lever to the OPEN position as the
engine warms up.
7. IF THE ENGINE DOES NOT START,
move the choke lever to the OPEN
position. Repeat steps 4 & 5 until the
engine starts.
Stopping the Vanguard Engine
CAUTION
DO NOT leave the saw unattended until the
engine is off and the blade has stopped
spinning.
NOTE: Do not choke the carburetor to stop the
engine.
1. Move the fuel valve lever to the OFF
position.
2. When the engine stops running, move the
choke to the CLOSED position.
Starting the Lifan Engine
Refer to the manufacturer’s engine manual as
the primary source of information regarding the
engine.
Warning
•
DO NOT leave the saw unattended while
the engine is running.
•
Always operate the saw in a well
ventilated area. Concentrated exhaust
can cause loss of consciousness and/or
death.
1. Move the fuel valve lever to the ON
position.
2. Move the choke lever to the CLOSED
position.
Fuel Valve Lever and Choke Lever
NOTE: To restart a warm engine, leave the
choke lever in the OPEN position.
Fuel Valve Lever
Choke Lever
Choke Lever
Fuel Valve Lever
22