![background image](http://html1.mh-extra.com/html/desa/ironhaus-yellowstone-idvf36hn/ironhaus-yellowstone-idvf36hn_owners-operation-and-installation-manual_2486369020.webp)
www.ironhaus.com or www.desatech.com
123129-01A
20
Figure 31 - Installing the WRC Remote
Receiver
Fireplace
Receptacle
Remote
Control
Receiver
Extension Cord
Ignition
Module Plug
REMOTE CONTROL INSTALLATION
(MODEL WRC)
1. Remove center brick/control cover.
2. The WRC model receiver does not require
a battery. To install receiver:
a. Plug short extension cord into fireplace
receptacle.
b. Plug receiver unit into extension
cord.
c. Plug ignition module into receiver unit
(see Figure 31).
3. Activate remote handset battery by re-
moving insulating tab on back of handset
(see Figure 32). Battery is included pre-
installed.
4. Once battery is activated, the unit is ready
to use.
5. Replace center brick/control cover.
Figure 32 - Installing Battery into Back of
Handset
Battery Cover
Back of
Handset
FirePLAce inStALLAtiOn
Continued
Figure 28 - Installing Lava Rock
Figure 29 - Installing Ember Flakes
Figure 30 - Installing Scrap Log Pieces
Lava
Rock
Ember
Flakes
Scrap Log Pieces
3. Place ember flakes around front and sides
of burner and on burner ports (see Figure
29). This will create the glowing ember ap
-
pearance as the flame touches the ember
flakes. Do not block burner ports or pilot
ports by overlapping ember flakes in one
area. It is not necessary to use all ember
material provided.
4. Place scrap log pieces randomly as shown
in Figure 30 on lava rock and around (but
not on) burner ports.
Pull to Remove
Insulation Tab
12 Volt Battery