![background image](http://html1.mh-extra.com/html/desa/ironhaus-yellowstone-idvf36hn/ironhaus-yellowstone-idvf36hn_owners-operation-and-installation-manual_2486369022.webp)
www.ironhaus.com or www.desatech.com
123129-01A
22
6. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the
floor. If you smell gas, STOP! Follow “B”
in the safety information on page 21. If
you don't smell gas, go to the next step.
7. Turn equipment shutoff valve counter-
clockwise
to the ON position. Do
not force.
8. Replace center brick/control cover.
9. Turn on all electric power to appliance.
10. Turn safety shutoff switch to the ON posi-
tion.
11. Visually locate pilot. Ignitor should begin
to spark and main burner should ignite
once flame appears at pilot.
• If lighting appliance for the first time each
season, it may take several attempts
before supply gas can reach pilot and
main burners.
• If appliance will not stay lit after several
attempts, follow instructions under
To
Turn Off Gas To Appliance
and call your
service technician or gas supplier.
TO TURN OFF GAS
TO AppLIANCE
1. Turn off safety shutoff switch.
2. Turn off all electric power to appliance if
service is to be performed.
3. Remove center brick/control cover.
4. Turn equipment shutoff valve clockwise
to OFF. Do not force.
5. Replace center brick/control cover.
REMOTE
OpERATION
1. Turn equipment shutoff valve to ON posi-
tion. You can now turn the burner on and
off with hand-held remote control unit.
IMPORTANT
: Be sure to press ON/OFF
buttons on hand-held remote control unit
for up to 3 seconds to assure proper
operation.
2. Press ON/OFF button to turn burner on
and off.
Figure 33 - Turning Equipment Shutoff
Valve to the OFF Position
Equipment
Shutoff Valve
Pilot Adjustment
Screw
Sensing
Rod
Pilot
Burner
Ignitor
Figure 34 - Pilot
inSPectinG BUrnerS
OPerAtiOn
Continued
BURNER FLAME pATTERN
Burner flames will be steady, not lifting or float
-
ing. Flame patterns will be different from unit
to unit and will vary depending on installation
type and weather conditions.
Pilot
Burner
Ignitor/
Sensor
Figure 35 - Correct Pilot Flame Pattern
Sensing
Rod
Check pilot flame pattern and burner flame
patterns often.
pILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame. Alterations may have occurred
during shipping and handling. The pilot is
located on right hand side of burner.
The flame must envelope 1/4" of top of the
ignitor/sensor and grounding stem.
If your pilot assembly does not meet these
requirements:
• Turn the adjustment screw marked PILOT
clockwise to decrease or counterclockwise
to increase the flame to proper size (see
Figure 33). Do not remove the adjustment
screw.
• see
Troubleshooting
, page 25