40
(Note 1)
“GS1 DataBar (RSS)” refers to all of the following codes: GS1 DataBar Omnidirectional (RSS-14), GS1 DataBar
Truncated (RSS-14 Truncated), GS1 DataBar Limited (RSS-14 Limited), GS1 DataBar Stacked (RSS-14 Stacked), GS1
DataBar Expanded (RSS-14 Expanded), GS1 DataBar Stacked Omnidirectional (RSS-14 Stacked Omnidirectional), and
GS1 DataBar Expanded Stacked (RSS Expanded Stacked).
(Note 2)
These code ID marks are contained in code data.
(Note 3)
Type 4 is a code ID mark system compliant with the AIM USA “Guidelines on Symbology Identifiers.” The “m” suffix is a
modifier character that differs depending upon options of individual symbologies as defined below.
Code type
“m”
(Modifier
character)
Options
0 Model
1
QR Code
1 Model
2
A
No FNC1 in the 1st character positions from start code
C
FNC1 in the 1st character positions from start code
iQR Code
E
FNC1 in the 2nd character positions from start code
0
mode 4, mode 5
MaxiCode
1
mode 2, mode 3
1 ECC-200
2
ECC-200 (FNC1 in the 1st or 5th character position from start code)
Data Matrix
3
ECC-200 (FNC1 in the 2nd or 6th character position from start code)
0 No
options
1
FNC1 preceding the 1st message character
2D codes
Aztec
2
FNC1 subsequent to the 1st character or digit pair
0
Scanning enabled, without a check digit
1
Scanning enabled, with a check digit (Check digit transmission enabled)
Interleaved 2 of 5
3
Scanning enabled, with a check digit (Check digit transmission
disabled)
0
Scanning enabled, without a check digit
1
Scanning enabled, with a check digit (Check digit transmission enabled)
Code 39
Code 39 Full ASCII
3
Scanning enabled, with a check digit (Check digit transmission
disabled)
0
Scanning enabled, without a check digit
1
Scanning enabled, with a check digit (Check digit transmission enabled)
Codabar
3
Scanning enabled, with a check digit (Check digit transmission
disabled)
0
No FNC1 in the 1st and 2nd character positions from start code
Barcodes
Code 128
2
FNC1 in the 2nd character position from start code
Example:
The code ID mark for Interleaved 2 of 5 with option “Scanning enabled, with a check digit (Check digit transmission
disabled)” is ]I3.
]: Flag character (ASCII 93h)
I: Code character (Interleaved 2 of 5)
3: Modifier character (See the table above.)
(Note 4)
For code ID marks not compliant with the AIM USA “Guidelines on Symbology Identifiers,” same characters as ones
defined in Type 1 apply.
