29
Chapter 8 Beeper, Indicator LED, Marker Beam, and Illumination LEDs
8.1 Beeper
(1) Beeping
The scanner emits a short or long beeps, once or a couple of times as described below.
The beeper emits a short beep when:
- the scanner has scan a code successfully,
- the scanner has scanned a Structured Appended QR (iQR) Code symbol,
- the “Start setting” or “End setting” code is scanned (3 beeps) or the parameter setting QR Code symbols are scanned (1
beep) from the QR-coded parameter menu (given in Chapter 11),
- the configuration software (Scan Tune App) starts up or accepts new settings (3 beeps),
- the scanner has scanned a batch-process QR Code symbol generated with the configuration software (Scan Tune App) (3
beeps),
- the scanner is turned on (4 beeps),
- a
Bluetooth
®
wireless link is established (2 beeps),
- the battery voltage has dropped, turning the scanner off (5 beeps, slightly longer), or
- the software keyboard ON/OFF switching function is used. (only at iPhone/iPad connection. 2 beeps)
The beeper emits a long beep when:
- the scanner has scanned Structured Appended QR (iQR) Code symbols in edit mode and the accumulated data exceeds 8
kilobytes,
- a code other than a parameter setting code is scanned during parameter setting by the QR-coded parameter menu,
- a transmission error or timeout occurred when the scanner was communicating with the configuration software (Scan
Tune App),
- the encryption key of read data does not match the one configured in the scanner in SQRC scanning (when the “data
transmission after mismatch of encryption key” is disabled),
- a communications error has occurred,
- an invalid control command is received,
- a
Bluetooth
®
wireless link is broken,
- you press the trigger switch and the magic key for three seconds or more and the power of the scanner is turned off, or
- the scanner has failed to save the parameter settings entered with the QR-coded parameter menu or the configuration
software.
You can disable the beeper using the QR-coded parameter menu or configuration software (ScannerSetting_2D)*. In any of
the following cases, however, the beeper sounds regardless of that beeper setting:
- when the scanner is being customized with the QR-coded parameter menu,
- when the scanner receives a beeper-ON command from the host computer,
- when the configuration software (Scan Tune App) starts up or any setting is newly reflected,
- when the scanner scans a batch-process QR Code symbol,
- when the parameter values are saved by a PW command (refer to Appendix 2),
- when the Bluetooth
®
wireless link is established or broken,
- when the battery voltage has dropped,
- when the scanner has failed to save the parameter settings, or
- when you press the trigger switch and the magic key for three seconds or more and the power of the scanner is turned off.
