Denso QK30-U, User Manual

Page: 14 / 114

3
Chapter 3 Connection to the Host Computer
The QK30-U receives and sends data from/to the host computer through the USB-COM interface or USB keyboard
interface. You need to set up the device driver designed for the interface to be used. (Refer to the section 3.1 and
section 3.2)
Notes for connecting the USB interface cable

To use the USB-COM interface, you need to install the serial port driver to the host computer before connection of
the USB interface cable.
Scanner
USB interface
cable

When plugging and unplugging the USB connector, put an interval of at least 10 seconds between those actions
since Windows may take several to 10 seconds to add or delete the USB device.

When the host computer is processing the scanner connection, do not plug or unplug any other USB device cables.

Directly connect the scanner to the USB port on the host computer or to the self-powered hub. The scanner may not
be connected to some types of hubs. If the operation of the hub-connected scanner is unstable, connect it directly to
any USB port on the host computer.

Do not use any extension cord.
Do not use computer's power management features
The scanner does not support standby, sleep, resume, hibernation, and other power management features;
therefore, disable their settings before setting up the scanner.
When communication software is open on a computer, disabling a suspend state may cause some computers to
be unable to communicate. If it happens, terminate the software and reboot the computer.