Denso BHT-1306B, User Manual

Page: 126 / 256

114
BHT-1300B series

Setting the DHCP
1.
Select “3: SET DHCP” at the SET TCP/IP menu and then press the
ENT
key.
The SET DHCP screen on the right is displayed.
The highlighted setting is the current setting.
Press and hold the
BS/C key
to return to the SET TCP/IP, FTP, DHCP or
DNS menu.
Press the dot key while holding down the
SF
key at the SET DHCP menu to
display the NETWORK (DHCP) screen (acquisition check screen for IP
address at DHCP).
Press the
BS/C
key at the NETWORK (DHCP) screen to return to the SET
DHCP screen.
- Point -
If the acquired IP configuration is displayed when the IP
address, subnet mask or default gateway is set to a value
other than ”0.0.0.0”, the DHCP does not display on the screen
shown on the right.
“1: TIMEOUT”:
Sets the timeout for acquiring the IP configuration from the DHCP
server. The entry range is from 00001 to 32767 seconds.
- Point -
Up to 32767 seconds can be entered, but in actual operation,
a maximum of 190 seconds is available since the number of
retries and retry intervals are determined by the system.
To set the DHCP:
(1) Press the
ENT
key.
(2) The mode changes to entry mode and the cursor is displayed, allowing the
setting to be entered with the numerical keys.
To delete a single character, press the
BS/C
key. To delete the entire entry, press and hold the
BS/C
key,
or press the
SF
key and
BS/C
key simultaneously.
(3) Enter the desired value, and then press the
ENT
key.
Press and hold the
BS/C
key to return to the SET TCP/IP menu.
BS/C
key /
SF
key + [.] key
SET DHCP
1：TIMEOUT [ 10]
2：LEASED IP
Release Reuse