ENGLISH
21
10 MEMO
★
Use this function to store the cue point, the pitch and the loop start point (A) and end point (B) in the memory and to call this data out.
★
Up to 300 sets of data, one set per track, can be stored in the memory.
★
The memory data can be copied between two RC-46s.
Storing data in the memory
1
2
Set the memo operation selection mode.
Set the player to the status you want to store in the
memory, then press the MEMO button.
Store the data in the memory.
Press the data master knob (
8
—
9
).
• If there are already 300 sets of data in the memory, “Memo
Full” is displayed and the data overwrite mode is set.
• The “
” indicator lights.
• The memo mode is canceled after 1 second.
MEMO
Memo Set?
Memo No.***
Overwriting data
3
4
5
6
7
If there are already 300 sets of data in the memory,
select “Over Write?”.
Set the memory overwrite mode.
Press the data master knob (
8
—
9
).
Select the data number you wish to overwrite.
Turn the data master knob (
8
—
9
).
Display “Memo Set?”.
Press the MEMO button.
Store the new data in the memory.
Press the data master knob (
8
—
9
).
Over Write?
Memo No.001
Memo No.***
Memo Set?
Memo No.***
Calling out data
1
2
3
4
Check that the “
” indicator is lit at the track
whose data you wish to call out.
MEMO
Set the memo operation selection mode.
Press the MEMO button.
Select “Memo Call?”.
Turn the data master knob (
8
—
9
).
Set the memo data call mode.
Press the data master knob (
8
—
9
).
• When the cue point is stored in the memory, the cue
point is search for and the standby mode is set.
When the A point is stored in the memory, the data for
the A point is loaded.
• “Loading (memory number)” is displayed on the character
display while the data is being loaded, and “Complete!” is
displayed once loading is finished.
Memo Call?
Clearing data
1
2
3
4
Set the standby mode at the track whose data you want
to clear.
Set the memo operation selection mode.
Press the MEMO button.
Select “Memo Clear?”.
Turn the data master knob (
8
—
9
).
Set the data clear mode.
Press the data master knob (
8
—
9
).
• The data is cleared and the “
” indicator turns
off.
• All the data in the memory can be cleared at once using
the “Memory All Clear” preset function (page 26).
MEMO
Memo Clear?
Complete!
MEMO DATA COPY
★
Two units of the DN-2600F are required (one master, one slave).
1
Connect the RC-46 remote control signal transfer connectors
(stereo mini jacks) with a cable as shown below.
Lch
Rch
GND
RC-46
Lch
Rch
GND
RC-46
2
3
Either open all the disc holders for the two sets or
remove all the discs.
Make presettings 14 and 15 and perform the memo
copy operation.
(Refer to page 26 for the presettings.)
(Tip)
(Ring)
(Ring)
(Tip)
(Sleeve)
(Sleeve)