Delta DX-2100 Series, User Manual

Page: 51 / 154

C h a p t e r 3 I n t r o d u c t i o n t o F u n c t i o n s
3 - 1 5
3_
Description Default
Options here are 1 to 3 days.
First IP Address
To increase the number of addresses available to clients, you can change
the Start Address.
192.168.1.100
Last IP Address
To increase the number of addresses available to clients, you can change
the End Address.
192.168.1.200
STP
STP is a network protocol that builds a logical loop-free topology for Ethernet
networks. The basic function of STP is to prevent bridge loops and the
broadcast radiation that results from them. If this STP is enabled, the traffic
usage will increase about 15Mbit in 24 hours.
Disable
PHY Auto Reset
Activate DIACloud DHCP after the account is bound. To determine whether
LAN needs to be reset if DIACloud is manually reboot or reconnected due to
unstable network.

Disable: Not allow LAN reset automatically.

Enable: Allow LAN to be reset which would cause a short period of
disconnection between devices and DX LAN ports
Notice:
It is suggested to disable DIACloud DHCP function and assign IP addresses in
manual mode.
Disable
An example of operation:
1.
Confirm “PHY Auto Reset” is set as Disable.
Instruction
1. Logged into www.diacloudsolutions.com
2. Click the secure tunnel and create a new network.
3. Enable the function to assign IP address
4. Log into DX webpage and bind your account to the DIACloud. Make sure if the
LAN port is receiving the DHCP IP address from DIACloud.
5. Go to NETWORK -> LAN Configurations -> PHY Auto Reset and select
Disable.
6. Connect the device to the LAN1 port.
7. Restart the Cloud service to see if the LAN1 is not trying to reconnect. (LAN1
should not be restarted.)
8. Connect your PC to LAN2 to ping LAN1 to see if the IP address of the LAN1
cannot communicate for a short time.