Delta DVS-G928 series, User Manual

Page: 30 / 206

D V S L a y e r 3 G i g a b i t M o d u l a r Ma n a g e d I n d u s t r i a l E t h e r n e t S wi t c h U s e r M a n u a l
3 - 1 2
_3
Description Factory default
Offset settings
Set up the offset time.
Note:
If you select the daylight saving mode as “Disable”, the configurations
will also be disabled.
Fixed
3.1.8 RIP
RIP (Routing Information Protocol) is one of the protocols which may be used by routers to exchange network topology
information. It is characterized as an “interior” gateway protocol, and is typically used in small to medium-sized networks.
A router running RIP sends the contents of its routing table to each of its adjacent routers every 30 seconds. When a route
is removed from the routing table it is flagged as unusable by the receiving routers after 180 seconds, and removed from
their tables after an additional 120 seconds. You can choose to enable or disable RIP in the section.
3.1.9 VRRP
A VRRP (Virtual Router Redundancy Protocol) is a computer networking protocol aimed to eliminate the single point of
failure by automatically assigning available IP routers to participating hosts. Using a virtual router ID (VRID) address and
virtual router IP (VRIP) address to represent itself, a virtual router consists of two or more physical routers, including one
master router and one or more backup routers. All routers in the virtual router group share the same VRID and VRIP. The
master router provides primary routing and the backup routers monitor the status of the master router and become active
if the master router fails.

VRRP Configuration
Description Factory default
VRRP Global

Mode : user can enable or disable VRRP Function.

Version : support VRRP V2 / V3.
Disable/V2
VRRP Group
For each VRRP Group, we provide several options:

VRID: Virtual Router ID, from 1 to 254.

VLAN ID: input VLAN ID, from 1 to 4096.

Primary IP: Input Virtual IP.

Priority: Priority, from 1 to 254.
Fixed