Delta Electronics AFE075A23A, User Manual

Page: 19 / 131

Chapter 5 Control Terminals

AFE2000 Series
5-17
Chapter 5 Control Terminals
Please remove the cover before wiring multi-function input and output terminals.
The appearance of following figures are for reference only.
Removes the cover for wiring
Frame B
Screw torque: 12~15Kg-cm [10.4~13lb-in.]
Loosen the screws and press the tabs on both sides
to remove the cover. Frame C&D
Screw torque: 12~15Kg-cm [10.4~13lb-in.]
MI1 MO1
MI5
MI3 MO2
MCM
MI7
MI4 MI2 S1 MI8 MI6 E24V SG- SG+
Removable Terminal Block
RA2 RC2 RB2 RB1 RC1 RA1
Open
120
485
A
B
DCM
E24V DCM COM
COM
Specifications of Control Terminal
Wire Gauge: 26~16AWG
（
0.1281-1.318mm
2
）；
Torque: (A) 5kg-cm [4.31Ib-in.] (0.49Nm) (Refer to the Figure: Removable Terminal Block)
(B) 8kg-cm [6.94Ib-in.] (0.78Nm) (Refer to the Figure: Removable Terminal Block)
Wiring precautions:

Reserves 5mm and properly install the wire into the terminal; fasten the installation by a
slotted screwdriver. If the wire is stripped, sort the wire before install into the terminal.

Flathead screwdriver: blade width 3.5mm, tip thickness 0.6mm

As shown in the figure above, S1-DCM is short circuit as the factory setting; and for
E24V-COM is short circuit SINK mode (NPN), please refer to the following figures for more
detail.