2.
You may begin taking readings
by firmly pressing the back of the meter onto the
material.
3.
This will display a relative reading
that ranges between 0 and 300. Once you are
satisfied with the value indicated for the selected location, press the
SELECT
key to
store a reading.
4.
You will notice the word HOLD
in the right hand side of the screen. If you press the
SELECT
key again the meter will store that reading and automatically increment to the
next defined location. (Example: LR, F then LR, W, then LR, C.)
If no storage is desired
for this location, manually select a different location by doing the
following:
1.
Use the
keys to
highlight
LOC
. Press
SELECT
to get into the
LOCATION
definition sub menu.
2.
Use the
keys
to change the location.
Note: You can only scroll through the pre-defined locations and areas as
described above.
3. Select
DONE
to save your new location;
CANCEL
to leave the previous location.
TO TAKE PIN READINGS IN ENHANCED MODE
TO SET THE ALARM IN ENHANCED PIN MODE:
1.
If you wish to set the alarm
to beep after a pre-selected value is reached, use the
key
from the
ENHANCED
main menu, highlight Option #4:
SET UP.
Press the
SELECT
key to
enter the
SET UP
sub menu.
2. Use the
key and highlight 6:
SET PIN MODE ALARM
. You will see a selection of
materials to choose from. Highlight the desired material and press the
SELECT
key.
Summary of Contents for navigator pro
Page 28: ...Blank page...
