°F mode, Absolute Humidity will be displayed in GPP. When in °C mode, Absolute
Humidity will be displayed in GPK.
TO RESET THE METER TO DEFAULT SETTINGS IN BASIC MODE:
1.
Use the
keys from the BASIC
main menu to highlight #5:
DEFAULTS
. Press
the
SELECT
key. The meter will display the following question:
2.
Use the
keys to answer “YES” or “NO.”
If you answer “yes,” the meter will
return to factory default settings in basic mode; i.e. Species = Oak, Temperature
correction = 70° F, Alarm = OFF in pin mode. In Scan mode, Alarm = OFF.
USING THE METER IN ENHANCED MODE:
To use Navigator Pro in enhanced mode, use the
keys to highlight #4:
ENHANCED
. The
Main Menu in ENHANCED mode is as follows:
Setting the meter to enhanced mode requires you to create job definitions and store readings as
described below.
NOTE: Although Navigator Pro’s default mode is BASIC, it will remember the mode last
saved at power off, and will remain in the saved mode at next power up.
Settings stored in each particular mode will not be affected by restoring defaults in a
different mode.
JOB DEFINITION:
Using Navigator Pro in
ENHANCED
mode allows you to define up to 5 jobs, and select locations
and materials being tested for each location. In this mode, Navigator Pro also stores each
reading and allows you to download the data to a PC or laptop via Infrared connection.
TO CREATE OR MODIFY A JOB:
Summary of Contents for navigator pro
Page 28: ...Blank page...
