Dell S4048T-ON, Configuration Manual

Page: 39 / 1146

OPENFLOW INSTANCE
PVST
PORT-CHANNEL FAILOVER-GROUP
PREFIX-LIST
PRIORITY-GROUP
PROTOCOL GVRP
QOS POLICY
RSTP
ROUTE-MAP
ROUTER BGP
BGP ADDRESS-FAMILY
ROUTER ISIS
ISIS ADDRESS-FAMILY
ROUTER OSPF
ROUTER OSPFV3
ROUTER RIP
SPANNING TREE
SUPPORTASSIST
TRACE-LIST
VLT DOMAIN
VRRP
UPLINK STATE GROUP
uBoot
Navigating CLI Modes
The Dell Networking OS prompt changes to indicate the CLI mode.
The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly through the
command modes, except for the
end
command which takes you directly to EXEC Privilege mode and the
exit
command which moves
you up one command mode level.
NOTE: Sub-CONFIGURATION modes all have the letters
conf
in the prompt with more modifiers to identify the mode and slot/
port[/subport] information.
Table 1. Dell Networking OS Command Modes
CLI Command Mode Prompt Access Command
EXEC Dell> Access the router through the console or
terminal line.
EXEC Privilege Dell#
• From EXEC mode, enter the
enable
command.
• From any other mode, use the
end
command.
CONFIGURATION Dell(conf)#
• From EXEC privilege mode, enter the
configure
command.
• From every mode except EXEC and
EXEC Privilege, enter the
exit
command.
NOTE: Access all of the following
modes from CONFIGURATION
mode.
AS-PATH ACL Dell(config-as-path)# ip as-path access-list
10 Gigabit Ethernet Interface Dell(conf-if-te-1/1)#
interface
(INTERFACE modes)
Configuration Fundamentals 39