Dell S4048T-ON, Configuration Manual

Page: 85 / 1146

EXEC Privilege mode
reload conditional nvram-cfg-change
• Reload the system into the Dell diagnostics mode.
EXEC Privilege mode
reload dell-diag
• Reload the system into the ONIE mode.
EXEC Privilege mode
reload onie [install | uninstall | rescue]
Use the
install
parameter to reload the system and enter the Install mode to install a networking OS.
Use the
uninstall
parameter to reload the system and enter the Uninstall mode to uninstall a networking OS.
Use the
rescue
parameter to reload the system and enter the Rescue mode to access the file system.
The following example shows how to reload the system:
Dell# reload
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into Dell diagnostics mode:
Dell#reload dell-diag
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE mode:
Dell#reload onie
Proceed with reload [confirm yes/no]: yes
The following example shows how to reload the system into ONIE prompt and enter the install mode directly:
Dell#reload onie install
Proceed with reload [confirm yes/no]: yes
Restoring the Factory Default Settings
Restoring the factory-default settings deletes the existing NVRAM settings, startup configuration, and all configured settings such as,
stacking or fanout.
To restore the factory default settings, use the
restore factory-defaults stack-unit {stack—unit—number | all}
{clear-all | nvram | bootvar}
command in EXEC Privilege mode.
CAUTION: There is no undo for this command.
Important Points to Remember
• When you restore all the units in a stack, these units are placed in standalone mode.
• When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units in the stack are affected.
• When you restore the units in standalone mode, the units remain in standalone mode after the restoration.
• After the restore is complete, the units power cycle immediately.
The following example illustrates the restore factory-defaults command to restore the factory default settings.
Dell#restore factory-defaults stack-unit 1 nvram
Management 85