Prefix-list with the last deletion/insertion: filter_ospf
ip prefix-list filter_in:
count: 3, range entries: 3, sequences: 5 - 10
ip prefix-list filter_ospf:
count: 4, range entries: 1, sequences: 5 - 10
Dell>
Applying a Prefix List for Route Redistribution
To pass traffic through a configured prefix list, use the prefix list in a
route redistribution
command.
Apply the prefix list to all traffic redistributed into the routing process. The traffic is either forwarded or dropped, depending on the criteria
and actions specified in the prefix list.
To apply a filter to routes in RIP, use the following commands.
•
Enter RIP mode.
CONFIGURATION mode
router rip
•
Apply a configured prefix list to incoming routes. You can specify an interface.
If you enter the name of a nonexistent prefix list, all routes are forwarded.
CONFIG-ROUTER-RIP mode
distribute-list
prefix-list-name
in [
interface
]
•
Apply a configured prefix list to outgoing routes. You can specify an interface or type of route.
If you enter the name of a non-existent prefix list, all routes are forwarded.
CONFIG-ROUTER-RIP mode
distribute-list
prefix-list-name
out [
interface
| connected | static | ospf]
Example of Viewing Configured Prefix Lists (ROUTER RIP mode)
To view the configuration, use the
show config
command in ROUTER RIP mode, or the
show running-config rip
command in
EXEC mode.
Dell(conf-router_rip)#show config
!
router rip
distribute-list prefix juba out
network 10.0.0.0
Dell(conf-router_rip)#router ospf 34
Applying a Filter to a Prefix List (OSPF)
To apply a filter to routes in open shortest path first (OSPF), use the following commands.
•
Enter OSPF mode.
CONFIGURATION mode
router ospf
•
Apply a configured prefix list to incoming routes. You can specify an interface.
If you enter the name of a non-existent prefix list, all routes are forwarded.
CONFIG-ROUTER-OSPF mode
distribute-list
prefix-list-name
in [
interface
]
•
Apply a configured prefix list to incoming routes. You can specify which type of routes are affected.
132
Access Control Lists (ACLs)
Summary of Contents for S4048T-ON
