86
Installing System Components
Figure 3-7.
Removing and Installing a Power Supply
Replacing a Power Supply
1
On a system with redundant power supplies, verify that both power
supplies are the same type and have the same maximum output power.
NOTE:
The maximum output power (shown in watts) is listed on the power
supply label.
2
Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-7.
NOTE:
If you unlatched the cable management arm in step 2 of the previous
procedure, relatch it. For information about the cable management arm, see
the system’s rack documentation.
3
Connect the power cable to the power supply and plug the cable into a
power outlet.
CAUTION:
When connecting the power cable, secure the cable with the Velcro
strap.
1
power supply handle
2
Velcro strap
3
release latch
1
2
3
Summary of Contents for PowerVault NX3000
