Terminal Mode Commands
79
BMC boot flag
valid bit clearing
(semi-volatile)
3
Data 1 - BMC boot flag valid bit clearing. Default = 0000b.
[7:5] - Reserved.
[4] - 1b = Do not clear valid bit on reset/power cycle caused by
PEF.
[3] - 1b = Do not automatically clear boot flag valid bit if IPMI
Chassis Control
command not received within 60-second time-out
(countdown restarts when a IPMI
Chassis Control
command is
received).
[2] - 1b = Do not clear valid bit on reset/power cycle caused by
watchdog timeout.
[1] - 1b = Do not clear valid bit on pushbutton reset / soft-reset
(for example, <Ctrl>-<Alt>-<Del>).
[0] - 1b = Do not clear valid bit on power up via power pushbutton
or wake event.
Table C-5. Boot Option Parameters
(continued)
Parameter
Number
Parameter Data (non-volatile unless otherwise noted)
Summary of Contents for PowerEdge 7250
