Dell PowerEdge 7250, User Manual

Page: 67 / 102

Using Console Redirection
65
Managing the Host System Remotely
After you configure the host and client systems (see "Configuring the Host System" and
"Configuring the Client System"), you can use console redirection to restart a host system or to
change a host system's configuration settings.
1
Reboot the host system using the client system.
See "Configuring Special Key Functions" for instructions.
2
When the host system begins to boot, use console redirection to:
• Enter the System Setup utility
• Enter the SCSI setup menus
• Update firmware and BIOS (flash the system)
• Run utilities on the utility partition
Configuring Special Key Functions
Console redirection uses ANSI or VT 100/220 terminal emulation, which is limited to basic ASCII
characters. Function keys, arrow keys, and control keys are not available in the ASCII character set,
and most utilities require function keys and control keys for ordinary operations. However, you can
emulate a function key or control key using a special key sequence, called an escape sequence.
An escape sequence starts with an escape character. You can enter this character in different ways,
depending on the requirements of your terminal emulation software. For example,
0x1b
and
<Esc> each represent the escape character. In HyperTerminal, you can create macros by selecting
Key Macros from the View menu. You can assign a macro to almost any key for almost any key
combination. Create a macro to represent each function key.
Table B-1 lists the escape sequences that represent a special key or function.
NOTE:
When creating macros in HyperTerminal, press <Insert> before <Esc> to signify that you are
sending an escape sequence rather than escaping out of the dialog box. If you do not have this function,
you must upgrade HyperTerminal.
NOTE:
Escape-sequence key combinations listed in Table B-1 are case-sensitive. For example, to
generate the character <A> you must press <Shift><a>.
Table B-1. Supported Escape Sequences
Key(s) Supported Sequence Terminal Emulation
<Up arrow> <Esc><[><A> VT 100/220, ANSI
<Down arrow> <Esc><[><B> VT 100/220, ANSI
<Right arrow> <Esc><[><C> VT 100/220, ANSI
<Left arrow> <Esc><[><D> VT 100/220, ANSI