8. Replace the computer cover, and reconnect your computer and peripherals to their power sources and turn them on.
9. Enter System Setup, and confirm that the top line in the
System Data
area correctly identifies the installed processor(s).
See "
Using System Setup
."
10. While in System Setup, reset the chassis intrusion detector by changing
Chassis Intrusion
to
Enabled
or
Enabled-Silent
.
See "
Chassis Intrusion
" for instructions.
11. Run the
Dell Diagnostics
to verify that the new microprocessor is operating correctly.
Back to Contents Page
NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be
displayed at the next system start-up:
ALERT! Cover was previously removed.
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting
the chassis intrusion detector.
