Dell Networking 7048, Reference Manual

Page: 544 / 1788

544
IPv6 MLD Snooping Commands
ipv6 mld snooping vlan groupmembership-
interval
The ipv6 mld snooping vlan groupmembership-interval command sets the
MLD Group Membership Interval time on a VLAN or interface. The Group
Membership Interval time is the amount of time in seconds that a switch
waits for a report from a particular group on a particular interface before
deleting the interface from the entry. This value must be greater than the
MLDv2 Maximum Response time value. The range is 2 to 3600 seconds.
Syntax
ipv6 mld snooping vlan
vlan-id
groupmembership-interval
time
no ipv6 mld snooping
vlan-id
groupmembership-interval
time
• vlan-id — Specifies a VLAN ID value.
• time — MLD group membership interval time in seconds. (Range: 2-
3600)
Default Configuration
The default group membership interval time is 260 seconds.
Command Mode
Global Config mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#ipv6 mld snooping vlan 2 groupmembership-interval 1500
ipv6 mld snooping vlan immediate-leave
This command enables or disables MLD Snooping immediate-leave mode on
a selected VLAN. Enabling immediate-leave allows the switch to immediately
remove the layer 2 LAN interface from its forwarding table entry upon
receiving an MLD done message for that multicast group without first
sending out MAC-based general queries to the interface.
2CSPC4.X7000-SWUM204.book Page 544 Friday, March 15, 2013 8:22 AM