Dell Networking 7048, Reference Manual

Page: 1701 / 1788

System Management Commands
1701
Default Configuration
By default, Ethernet ports are configured to operate in Ethernet mode.
Command Mode
Stack Configuration mode
User Guidelines
The clear config command will not change the stacking port mode. Only the
stack-port command can change the operating mode of the stacking port and
it only takes effect after a reboot when changing between stacking and
Ethernet mode.
The stack-port configuration mode does not appear in the running config.
Use the show switch stack-port command to display configuration and status
of stacking ports. Ports that are configured to operate as stacking ports will
show as detached in the show interfaces status command output.
Use the show switch command to display information regarding the switches
in a stack.Redundant stacking links between any two units must operate at
the same speed. A 40G port configured in 4x10G mode is considered to be
operating at 10G speed.
Up to eight stack ports can be configured per stacking unit (four in each
direction).
The PC80xx and PC81xx switches support up to six units configured in a
stack and can utilize 10GBaseT, SFP+ or QSFP (81xx only) connections for
stacking.
Example
console(config-stack)#stack-port tengigabitethernet 1/0/3 stack
console(config-stack)#
standby
Use the standby command to configure the standby in the stack. This unit
comes up as the master when the stack failover occurs. Use the no form of
this command to reset to default, in which case, a standby is automatically
selected from the existing stack units if there no preconfiguration.
2CSPC4.X7000-SWUM204.book Page 1701 Friday, March 15, 2013 8:22 AM