2.
Place the hard drive into the carrier at an angle.
When the bumper clears the carrier, slide the hard drive toward the connector.
3.
Connect the hard drive to the connector in the carrier.
4.
Slide the tabs on the cover under the lip on the hard drive carrier.
5.
Replace the two M2.5 x 5-mm screws.
6.
Place the pin on one end of the bezel into the hole on the hard drive.
7.
On the other end of the bezel, replace the M3 x 3-mm screw that secures the hard drive bezel to the hard drive.
8.
Slide the hard drive into the hard drive bay.
9.
Replace the two M3 x 3-mm screws that secure the hard drive to the base assembly.
10.
Follow the procedures in
After Working on Your Computer
.
11.
Install the operating system, drivers, and utilities for your computer, as needed. For more information, see the
Setup and Quick Reference Guide that
shipped with your computer at
support.dell.com
.
Removing the Modular Hard Drive
1 hard drive 2 hard drive carrier
3 connector
1 M2.5 x 5-mm screws
2 cover
3 lip on hard drive carrier (2) 4 tabs (2)
Summary of Contents for Latitude E6400 ATG
