Figure 66. Installing the network daughter card
Next steps
1
Install the expansion card riser 2 or the rear hard drive cage, depending on the configuration of your system.
2
Follow the procedure listed in
After working inside your system
.
Related links
Installing an expansion card riser
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage controller
card provides the storage subsystem for internal hard drives of your system. The controller supports SAS and SATA hard drives and also
enables you to set up the hard drives in RAID configurations as supported by the version of the storage controller.
Removing the integrated storage controller card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the air shroud.
Steps
1
Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the system
board.
2
Lift the integrated storage controller cable to disconnect it from the connector on the system board.
116
Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components
