The
TPM Status
changes to
Enabled, Activated
.
Initializing the TPM 1.2 for TXT users
1
While booting your system, press F2 to enter System Setup.
2
On the
System Setup Main Menu
screen, click
System BIOS
>
System Security Settings
.
3
From the
TPM Security
option, select
On with Pre-boot Measurements
.
4
From the
TPM Command
option, select
Activate
.
5
Save the settings.
6
Restart your system.
7
Enter
System Setup
again.
8
On the
System Setup Main Menu
screen, click
System BIOS
>
System Security Settings
.
9
From the
Intel TXT
option, select
On
.
Control panel
A control panel allows you to manually control the inputs to the server.
Your system supports:
•
Left control panel: Left control panel contains status LEDs, system ID button, and iDRAC Quick Sync 2 (optional).
•
Right control panel: Right control panel contains power button, USB 2.0 ports,, micro USB for iDRAC Direct, and status LED for iDRAC
Direct.
Removing the left control panel
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
Remove the air shroud.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
4
For ease of removal of the left control panel, remove the cooling fan #1 to access the cable latch.
Steps
1
Pull the cable latch and disconnect the control panel cable from the system board connector.
2
Using Phillips #1 screwdriver, remove the screws that secure the cable cover.
152
Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components