Figure 78. Installing an expansion card int o the expansion riser 2A
Next steps
After installing a card into the riser 1, close the PCIe card holder latch. If applicable, close the PCIe guide after installing the expansion
card.
Follow the procedure listed in
After working inside your system
.
Install any device drivers required for the card as described in the documentation for the card.
M.2 SSD module
Removing the M.2 SSD module
Prerequisites
Follow the safety guidelines listed in
Safety instructions
.
Follow the procedure listed in
Before working inside your system
.
Remove the air shroud
.
Remove the BOSS card.
NOTE:
Removing the BOSS card is similar to the procedure for removing an expansion card riser.
Steps
Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
Pull the M.2 SSD module away from the BOSS card.
Installing and removing system components
123
