Figure 84. Installing the MicroSD card
Next steps
Follow the procedure listed in
After working inside your system
.
Network daughter card
Removing the network daughter card
Prerequisites
Follow the safety guidelines listed in
Safety instructions
.
Follow the procedure listed in
After working inside your system
.
Remove the expansion card riser 2 or the rear drive cage, depending on the configuration of your system.
Steps
Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Installing and removing system components
129