Figure 114. Installing the VGA module
Next steps
Route the VGA cable and connect it to the VGA connector on the system board. For locating the connector, see the
System board
jumpers and connecters
section.
Install the air shroud
.
Install the backplane cover
.
Install the front bezel
.
Follow the procedure listed in
After working inside your system
.
.
Optional internal USB memory key
An optional USB memory key can b e installed in the internal USB 3.0 port.
NOTE:
To locate the internal USB port on the system board, see the System board jumpers and connectors section.
For configurations that support USB 3.0 module, the USB 3.0 module cable connects to the internal USB port on the system board. In this
scenario, the default internal USB port is available under the backplane cover. The position of the default internal USB port may vary
depending on the configuration of your system.
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of the USB
memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
Follow the safety guidelines listed in
Safety instructions
.
Follow the procedure listed in
Before working inside your system
.
Steps
Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
Jumpers and connectors
.
If installed, remove the USB memory key from the USB port.
Installing and removing system components
151
