Dedicated Micros CamVu 720, Installation And Configuration Manual, Page: 75 / 160

75
Installation Guide
Tip : Use DHCP to locate a free IP address, then fix the unit IP address to the free one by entering the details
into the IP address, subnet and gateway fields.
Max Transmission Rate kbits/sec
This shows the maximum transmission speed for the network type
being used. If set to ‘0’, transmission speed is not limited in the camera.
Note: This setting will limit and override any higher transmission rate entered in the Video Transmission
menu (Configuration menu->Live Trans).
Force 10BaseT operation The unit supports 10 or 100BaseT half duplex transmission. Selecting
this option will force the unit to operate at a 10BaseT connection.
Tx Image Buffers This is used in order to improve the picture delivery over Ethernet when
using a slow connection i.e. 256Kbps. A buffer setting of 1,2 or 3 is
available (default setting is 1).
Ethernet MTU Bytes This is the maximum transmit unit for the Ethernet packet. The MTU is
the largest physical packet size measured in bytes that the network can
transmit. By default this figure is set to 1500bytes.
Max Transmission Timeout ms This is the time (in milliseconds) the unit will wait to re-send a packet if
an acknowledgement is not received.
Reset (Red) Resets the unit to apply changes.
Rem Report (Green) Opens the Network Settings->Remote Reporting page.
Webcam (Yellow) Opens the Network Settings->Web Camera Configuration page.
Email (Blue) Opens the Network Settings->Email page.
Refresh (Purple) Refreshes the current page.