Davin Toscana-C1b, Service Manual

Page: 176 / 365

Code Possible Cause
0082 TX unit received a signal other than DIS or DTC, or DCN in Phase B.
0083 FSK signal detected no signal received within 35 sec.
0084 Detected DCN signal in Phase B.
0085 TX unit sent DCS 3 times but each send met DIS/DTC response.
0086 After DCS sent response signal was other than DTC, DIS, FTT, DCN or CFR.
0087 Training attempt failed because machine speed could not adjust to low speed.
0088 Received DCN signal after DCS signal sent.
0089 Remote machine has no mailbox function or mailbox function is not compatible.
008B Local RX machine received DIS protocol but protocol not compatible.
008C Local machine memory insufficient for starting relay sending.
008D
Received RX machine DIS protocol but remote machine could not receive document
because it was out of paper, or for some other reason.
008F Modem was not ready to receive V.34 data within 6 sec. after it received CFR signal.
0090 Remote machine not ready for document polling.
0091 DCS+TCF signal sent 3 times but no response signal in response.
0093 DCN signal received after DCS signal sent for V.34
0094 Time-out during ECM frame or RCP command transmission.
0095 Wrong ID number for polling RX or mailbox TX.
0096 Sub-address or password mismatch in polling RX mode.
009A No signal detected after CI signal sent.
009D Remote machine hung up before V.34 modem entered Phase 2 during V.34 polling RX.
009E Manual TX over 15 min. in Phase C of non-ECM mode.
00A0 Operator stopped or cancelled TX job.
00A1 Document jammed during transmission
00AE V.8 procedure did not complete, or no V.21 signal detected after CM signal within 30 sec.
SC Error Codes
175
4