9
STORAGE AND SAFETY
1. Store in a dry, covered place away from direct sunlight for longer bag life
2. Always use the entire bag content of EcoMineral Salt, once opened. Do not keep open bags of EcoMineral Salt
as it is sensitive to moisture in the air.
3. Care should be taken to avoid contact with eyes and inhaling salt dust. Wearing eye protection and a dust mask is
good practice.
4. If eyes become affected, flush with clean tap water.
5. If skin becomes irritated, immediately wash contaminated skin with plenty of water and then wash with soap
and water.
• CHLORINE
- For a new pool installation that has not been chlorinated, add sufficient Chlorine (liquid or
granular) to achieve a reading of 3 ppm (with a suitable test kit), or run the Sanitiser system continuously for at
least 24 hours or until a reading of 3 ppm is reached.
• STABILISER
- It is essential that pool stabiliser be added and maintained at the rate of 30 - 50 ppm at all times.
Do not exceed 100 ppm.
(FOR OUTDOOR POOLS ONLY)
• (Refer Day to Day Operation page 15 for further information).
OPERATION OF YOUR ECOMINERAL SYSTEM
Cell Output
is expressed as a percentage. Set the system control to the percentage output required and the
unit will automatically adjust the cell output to the set level. The Unit is fitted with an electronic control and
warning system. This regulates the output of the Unit to the preset maximum and changes cell polarity as
indicated by POLARITY LEDs A&B. These LEDs will alternate over a number of hours or days depending on
how the unit is set to operate. The warning system consists of one
Operation LED
which will glow Green to
indicate normal operation or RED to indicate possible faults with the Unit or damaging operating conditions.
