4
IMPORTANT INFORMATION
ABOUT YOUR SANITISER
FACTORS THAT WILL IMPROVE THE PERFORMANCE
& LIFE OF YOUR ECOMINERAL WATER SANITISER
PLEASE READ THIS BEFORE OPERATING YOUR SANITISER
POOL BUILDERS:
Please cover this information with your customer during the
new pool “Handover Session”
Sanitisers are a valuable piece of pool sanitising equipment and must be cared for to get the best
performance and life span from it.
There are THREE main factors that will damage your Sanitiser and reduce the life of the product.
Please monitor the following factors in accordance with your installation & operating instructions.
1. MAINTAIN RECOMMENDED TOTAL DISSOLVED SOLIDS (TDS) LEVELS
RECOMMENDED OPERATING RANGE: 4,000 - 6,000ppm
• Run Sanitiser at the TDS levels stated within this document and on the product to ensure
optimum sanitiser output and cell life.
• Operating this device at low TDS levels will damage the cell and reduce its life.
• The control panel displays a red LED indicator warning when the TDS levels are low.
• If no action is taken to rectify the TDS levels, damage to the cell may result which will not be
covered under warranty.
2. MONITOR & MAINTAIN YOUR SANITISER IN-LINE CELL
EcoMineral has a “Reverse Polarity” In-Line cell.
• To keep your EcoMineral Sanitiser in the best possible condition, regular monitoring of the
electrolytic cell is recommended. The ‘Cell’ is the clear plastic housing containing the plates.
• During the sanitisation process a white powdery Calcium scale may naturally build up on the
titanium plates in the cell. Monitor the cell to prevent excessive scale build up. Excessive scale
build up will cause damage to your cell, and dramatically reduce its efficiency and lifespan.
• Reverse Polarity models have low maintenance cells that minimise scale build up.
• The control panel displays a red LED indicator warning when the cell requires cleaning.
• If Calcium scale builds up please clean the cell, following the cleaning instructions provided on
page 14.
• NEVER
: Use concentrated acid to clean your cell.
• NEVER
: Leave cell in cleaning solution for extended periods of time
• NEVER
: Use metal implements, scourers or brushes to clean your cell
3. BALANCED POOL WATER CHEMISTRY
• EcoMineral Salt and Activator TDS levels
MUST
be maintained at
4,000 - 6,000ppm
for optimum performance and lifespan
• Calcium Hardness levels
MUST
be kept to ideal ranges of
200 - 275ppm
(for Concrete and
Tiled Pools) and
100 - 225ppm
(for other surfaces) to prevent excessive scale build up and
damage to equipment
• pH levels
MUST
be kept to ideal levels to prevent damage to equipment and pool surfaces and
to obtain optimum sanitiser effectiveness.
• Total Alkalinity and Stabiliser levels must also be kept in an ideal range.
Note: Please refer to the POOL WATER CHEMISTRY chart on page 17 for more information.
