![Daum electronic ergo_lyps User Manual Download Page 48](http://html1.mh-extra.com/html/daum-electronic/ergo_lyps/ergo_lyps_user-manual_514125048.webp)
3.1
4 / 4a
4-1
4b
4b-2
4b-1
4b-3
4b-1
M 5
Description
Installing the oscillating poles
Assembly
3. Assembling instructions
/ Assembling and installing the oscillating poles
Required hardware:
1 oscillating pole (4 / 4a) right /left with the handle padding (4-1)
Required tool:
Wrench #13
2 Handle extensions (4b)
2 M8 screws/C, 2 washers/E, 2 spring washers/K
The oscillating poles (4/4a) have special handle extensions (4b) to reduce the packaging. These
extensions (4b) must be fitted to the poles (4/4a) before installing them. Since these extensions (4b)
are held in place on the poles (4/4a) by friction only, they must be installed by hammering in position
with a plastic or rubber hammer, or with a normal hammer with a shock absorber (wood or plastic pad)
between the hammer and the handle. The handle padding (4-1) of the oscillating poles (4/4a) must
neatly meet that of the handle extensions (4b) and not form a gap between them.
3.
1
3.
2
3.
3
The extensions (4b) are made up of two similar halves (4b-1/4b-1) that are held together by a sheath.
A sleeve (4b-3 / an elastic rubber tube) covers the two halves (4b-1). The end caps (4b-2) hold the halves
together firmly after they are fitted into the oscillating poles and prevent the opening of the halves.
We recommend following the procedure illustrated below to insert the handles (4b) into the oscillating
poles. The best thing would be you find an underlay (a mat or something similar) and lean (press)
the lower end of the oscillating pole against a wall to prevent the slipping of the round bearing on the
floor and avoid damaging surrounding furniture. Press the two halves together (4b-1) with your hand or
by mean of pliers in order to be able to insert them into the tube of the oscillating pole before hammering
them. When doing this, you should take care that the longitudinal ribs on the handles do not come into
contact with the internal tube seams. You should o
. Otherwise, you would only damage the
handle (4b).
nly start the hammering process after the halves are
inserted into the tube
tube of the
Press the two halves (4b-1) together by hand before introducing
the handles into the oscillating poles (4/4a) so that they can be
introduced into the tube and then be hammered in place.
You should lean the oscillating poles (4/4a)
against a wall or any corner, on a protective
underlay, to keep them from slipping while
hammering the handles in place, and avoid
damaging the floor.
Use a shock absorber,
e.g. piece of soft wood,
if no plastic or rubber
hammer is available
Handle / 4b
The sleeve (4-1) of the oscillating
pole is already installed. It leaves
about 1 cm uncovered.
Protective underlay /
Mat
Summary of Contents for ergo_lyps
Page 1: ...fitness ...