3.
5.
6.
4a
5a
4.
prog
2.
prog
1.
reset
00
)
))
)
))
)
))
watt
IL
manual
program
29
1 x
1 x
1 x
1 x
Selection and programing of the Individual Program IL
The
ergo_lyps
modell
fitness
is equipped with an individual training program /
IL
. It allows you to program
a
30 minutes individual watt program.
These entries
can be repeated for a
total of 30 minute-steps for user identification numbers “1 to 4”.
After confirming the last training minute start pedalling to run the individual program.
(up to 30
one minute
steps)
displays:
displays:
the prog. number
Confirming a setting of
terminates the programming
operation.
Window 5
Window 2
Window 1
Window 4
Window 6
displays:
displays:
displays:
e.g.
e.g.
e.g.
Users /
km total
displays:
the selected user number
evtl. a program number
evtl. a program arrow
P
displays:
displays:
P
the
short designation
and the required
Prog. designation
displays:
empty display
if programming
the IL prog. for
the first time or
e.g.
A blinking signal
indicates that the
watt values can
be entered for a
new program
The diagram of
the last individual
IL program
entered
e.g.
This setting
can be modified
in one-minute
step. The bar
corresponding
to the current
minute blinks
to indicate
how the diagram
will be modified
confirm
press
until the arrow in
Window No. 4
pointing to
User / km total
appears on the right side
press
evtl. a Prog. Nr.,
evtl. a Prog. Name
displays:
turn
until
window no. 1
displays the
Prog. designation “
IL”
and in
press
the watt load prescribed
for the first minute
is displayed
For the Watt Individual
Program / IL
E
I
0
= Entry
= first minute
of training
Should the displayed value be modified?
Turn the control button No. 6 to set:
The watt value required for the first training minute of the IL - program
Confirm
the setting
E
2
= Entry
= second minute
of training
Should the displayed value be modified?
Turn the control button No. 6 to set:
The watt value required for the second training minute of the IL - program
Confirm
the setting
the watt load
prescribed for
the third minute
is displayed
E
3
= Entry
= third minute
of training
etc.
Confirm
the setting
When this program is run, the display follows the same pattern as for normal watt controlled programs.
The graphic display also supports the programming of an individual program: The stored program is
displayed on the screen, with a blinking bar corresponding to the watt value for the current minute that
can be modified by turning the control button. This bar represents the preset watt value for the minute
displayed in window 2. When you press the control button, the next bar starts blinking and can
be changed.
the watt load
prescribed for
the second minute
is displayed
press
press
displays:
The following table shows how to call and configure this program.
0
window no. 2
appears
Individual Program / IL
Training programs
evtl. a Prog. Nr.,
evtl. a Prog. Name
Summary of Contents for ergo_lyps
Page 1: ...fitness ...
