Datum MobileTrak5, Installation Instructions Manual

Page: 17 / 28

Figure 1E
Figure 1F
1G
Detail 1G
MobileTrak5 Upright Installation Instructions
Page 17
Mount end panel uprights using (4) 1/4-20 x 3/4" hex
bolts (see figure 1E). Do not fully tighten at this time.
Place top spacer bracket over studs on top of uprights.
Finger tighten (4) #10 - 24 flange nuts on studs.
Making sure that uprights are square, and top spacer's
flange is against top of shelving; tighten 1/4-20 bolts
and #10-24 flange nuts.
Screw #8 x 1/2" Tek screws into top of shelving on
carriage through holes in top spacer bracket (see
Figure 1F).
Attach female end panel clips to uprights using (2) #8
x 1/2 sheet metal screws per clip (see Detail 1G). The
clip opening should be facing away from shelving. If
using 3 piece end panels, clips will be used on all sets
of holes in uprights. If using a 1 piece end panel, clips
will be used in bottom holes, top holes, and the fourth
set of holes from the bottom.
TOP SPACER
BRACKET
#10 FLANGE NUT
1/4-20 x 3/4"
HEX HEAD BOLT
END PANEL UPRIGHT
TOP SPACER
#8 x 1/2"
TEK SCREW
SHELVING
UPRIGHT
#8 x 1/2" SHEET
METAL SCREW
END PANEL CLIP
(FEMALE HALF)