Datum MobileTrak5, Installation Instructions Manual

Page: 5 / 28

Figure H
Figure K
Figure J
NOTE: BE SURE TO USE DECK SPLICE PLATES BETWEEN SECTIONS OF RAMP
Figure I
RAIL
RAMP
RAIL
FILLER
METAL SECTION
#10 x 3/4" PARTICLE BOARD SCREW
WOOD SECTION
#10 x 1 1/4" FLAT HEAD
PHILLIPS TEK SCREW
RAIL
BRACKET
#10 x 3/4" PARTICLE
BOARD SCREW
2 SHIMS
DECKING
1/4" CLEARANCE BETWEEN
DECKING & INSIDE OF BRACKET
MobileTrak5 Ramp Installation Instructions
Page 5
INSTALLING RAMP
The ramp installs with the flange of the ramp
resting on the lip of the front rails (see Figure H).
The ramp does not need to be secured to rail but
can be if necessary. To secure: Drill pilot holes
(approximately 48" apart) through the ramp into
the flange of the rail. Then using #10 x 1" long
self-tapping screws, secure the ramp to rails.
NOTE: Ramp runs entire length of system
including under the stationary units.
INSTALLING A.D.A. COMPLIANT RAMP (OPTIONAL)
Attach the metal ramp section to the wood ramp section using #10 x 3/4" particle board screws (see
Figure J). Lay the assembled section of the ramp on to the front most rail and attach using #10 x 1
1/4" flat head Phillips Tek screws. Repeat step for additional sections of ramp. Be sure to use deck
splice places between ramp sections.
INSTALLING SIDE RAMP (OPTIONAL)
In some cases, side ramps are installed on exposed
ends of systems (see Figure I). Use #10 x 3/4"
particle board screws to attach angle and shims to
bottom side of decking board before installing
decking board on system. The front ramp and the
side ramp will need to be miter cut in the field.
Refer to the customer layout for location of the
ramps.
INSTALLING FILLER (OPTIONAL)
Track filler is used to fill the gaps
between the anti-tip channel and the
rail. It is placed in the rail over the
adjuster screws (see Figure K). Two
different sizes of track filler are used
(see page 06).