DSV2+
Turbo
User Manual, Version 1.09
7
Copyright
©
2006 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
2. Unpacking & Inventory
Depending on the number of terminals ordered, your
DSV2+
Turbo
units and accessories may be
shipped in a single pack box, a multi pack box or some number of each type. Carefully open the
shipping box(s) and use the following Shipping Box Inventory list to verify the contents.
Shipping Box Inventory:
•
DSV2+
Turbo
Smart Card Reader
•
Universal (90-240 VAC input) DC power/charging adapter.
•
AC power cord for DC power/charging adapter. (Plug depends on country of destination)
•
Documentation, including: User Manual (on CD), End User License Agreement, and
Quick-Reference Guide.
Please retain the shipping box in the event you need to return your product for service.
3. Initial Setup
•
Each unit is shipped with one Lithium Polymer battery installed, though
disconnected
.
To connect the battery, you will need to remove the rear battery access cover and plug the
battery connector into the mating connector on the left hand side of the battery
compartment.
•
It is
recommended
that you fully charge the internal battery before use to maximize
operating time before recharging is required. The unit will operate when connected via
the AC adapter regardless of the charge state of the internal battery.
•
The DSV2+ contains an integrated charging circuit that allows the batteries to be charged
inside the unit whenever the unit is properly connected to the AC adapter. No external
standalone charger for batteries is required.
Please refer to Section 5. 0 “Battery Charging and Replacement”, for additional instructions and
safety information.
