DSV2+
Turbo
User Manual, Version 1.09
49
Copyright
©
2006 by Datastrip, Inc. All rights reserved.
Reproduction in whole or in part is prohibited.
IR Scanner Settings:
From the menu select “Scanner” and then select “Scanner settings…”
•
Make sure the “IR” box is checked
•
Set Intensity=35%.
•
Leave all the other settings as default
Scan Region:
Left and Right: The parameters that define the length of the symbology that will be scanned on a
document. Left defines how far from the beginning of a document that the symbology starts.
Right defines how far from the beginning of a document that the symbology ends.
Top and Bottom: The parameters that define the width of symbology that will be scanned on a
document. Top defines the outside edge of the card guide and Bottom defines in the inside edge
of the card guide.
The default scan regions are set to the maximum length and width as follows:
DSV2+
Turbo
-PA
DSV2+
Turbo
-SW
Left = 0 inches
Left = 0 inches
Right = 5 inches
Right = 5 inches
Top = 0 inches
Top = 0 inches
Bottom = 3.36 inches
Bottom = 1.14667 inches
Example:
Resolution:
When scanning OCRB documents the scanner resolution can be set for 200, 300 or 600 DPI.
When scanning Datastrip symbologies the resolution should be set for 600 DPI.
3.36”
0
BOTTOM
TOP
0
LEFT
5”
RIGHT
