V180817w
iBoot-G2+ / iBoot-G2S
Page 32
Expansion Commands
These commands are only available to the administrator.
get expansion
This command displays the current settings of the
expansion ports. The response to this command is
determined by the expansion mode setting.
If iBoot-Exp mode:
Mode: iBoot Expansion Units
Link:
Exp 1: Yes
Exp 2: No
If Power:
Mode: Power Control
Input 1: Main On
Input 2: Main Off
If Independent I/O mode:
Mode: Independent I/O
Output:
Exp1:
IP Address: 192.168.1.200
Relay: 1
Exp2:
IP Address: 192.168.1.205
Relay: 1
set expansion mode <exp | io | power>
This command sets the mode for the expansion ports to
iBoot-Expansion or External I/O or Power Control
exp
set expansion <exp1 | exp2> link
<yes | no>
This command sets the Exp1 or Exp2 to be linked to the
main outlet for simultaneous control. This command
takes effect only when expansion mode is
iBoot Expansion Units.
no
set expansion <exp1 | exp2> ipaddress
<dotted decimal>
This command sets the IP address to send input status
information via DxP protocol to. This command takes
effect only when expansion mode is Independent I/O.
set expansion <exp1 | exp2> relay <1-8>
This command sets the DxP command relay number to
be controlled by input changes from Exp1 or Exp2. This
command takes effect only when expansion mode is
Independent I/O.
Exp 1: 2
Exp 2: 3
set expansion <exp1|exp2> username
<20 characters>
This command sets the DxP command username. This
command takes effect only when expansion mode is
Independent I/O.
set expansion <exp1|exp2> password
<20 characters>
This command sets the DxP command password. This
command takes effect only when expansion mode is
Independent I/O.
