DISPLAY AND KEYPAD
8
8.3 DISPLAY MESSAGES
The messages shown on the SC4000 display are divided into different categories each with
its own priority depending on the level of importance.
Below is the list of messages, and a few examples providing help to interpret the information
reported.
Execution Message
Type
Display
Critical Procedures
Genius™
File Transfer
File receiving messages: Receiving, Received,
Checking file, Saving file, File saved,
Restarting, File not saved, Wrong software
version.
File transmission messages: Transmitting,
Transmitted, Transfer failed
Genius™
SC4000
Backup & Restore
Backup Result: Done, Error, CBX write
protection enabled,
Restore Result: Done, Error, Backup missing
Genius™
NET-Autoset
Start searching new nodes, Stop searching
new nodes, Found new node assigned
address, Replacing device,
Genius™
Restore Default
Parameters
Keep pressed to set default, Setting default,
Default set
SC4000
SC4000 Menu
Menu Selection
Exit, Network State, Reading Mask, Backup,
Restore
Network
Diagnostic Alarms
Generic alarm
Alert failure yyy
Network alarm
(Master ID-NET)
Node xx duplication, Node xx missing, Node
xx configuration
ID-NET: Slave local alarm Node xx Fail yyy,
CBX alarm
Fieldbus failure, Fieldbus mismatch, (Rotary
switch) wrong selection, Communication
failure, DHCP problem
Operation
Reading Results
Reading result
Reading mask
Reading, No Read, Good Read, Multiple
Read, Partial Read, Good Code, Wrong Code
Powerup
Welcome Messages
Welcome and Startup
Model, Software, Network Configuration, Host
Interface Module Type
* Diagnostic Alarm Messages can be enabled/disabled in Genius™.
43
