Datalogic QuickScan I QD24 Series, Product Reference Manual

Page: 254 / 282

Technical Specifications
244 QuickScan™ I QD24XX
Table 48
Programming Mode - The following indications ONLY occur when the reader is in Programming Mode.
Label Program-
ming Mode Entry A valid programming label has
been scanned.
LED blinks continuously
Reader sounds four low fre-
quency beeps.
Label Program-
ming Mode
Rejection of Label
A label has been rejected. N/A
Reader sounds three times at
lowest frequency & current vol-
ume.
Label Program-
ming Mode
Acceptance of
Partial Label
In cases where multiple labels
must be scanned to program one
feature, this indication acknowl-
edges each portion as it is suc-
cessfully scanned.
N/A
Reader sounds one short beep at
highest frequency & current vol-
ume.
Label Program-
ming Mode
Acceptance of
Programming Configuration option(s) have
been successfully programmed
via labels and the reader has
exited Programming Mode.
N/A
Reader sounds one high fre-
quency beep and 4 low fre-
quency beeps followed by reset
beeps.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has been scanned. N/A
Reader sounds two times at low
frequency and current volume.
. Programming Mode Indications
Error Codes
Upon startup, if the reader sounds a long tone, this means the reader has not passed its automatic
Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is reset, the
sequence will be repeated. The following table describes the LED flashes/beep codes associated
with an error found.
NUMBER OF LED
FLASHES/BEEPS
ERROR :
QD24XX
CORRECTIVE ACTION
1 Configuration
Contact Helpdesk for assis-
tance
2 Interface PCB
6 Digital PCB
12 Imager