Datalogic ENC-58 PROG, Instruction Manual, Page: 36 / 38

ENC58 PROG
31
has HIGH logic level (+VDC) the encoder will provide the increasing
count when the shaft is turning clockwise (and the decreasing count
when the shaft is turning counter-clockwise).
USB to I2C not found: check connections!!!
This warning message is triggered if the encoder is not connected
properly and the software tool is not able to establish a USB
connection. In such occurrence please check that the USB cable is
connected properly to the USB port and the USB port is working
correctly.
Would you like to update also encoder parameters?
The operator has pressed the Load config button (or otherwise as an
alternative the Load config command in the File menu) in order to
upload a previously saved encoder configuration.
After having select and confirmed the .cfg or .hex file to upload, the
Would you like to update also encoder parameters? message
appears on the screen after a few seconds.
If you choose YES, the configuration parameters are updated in both
the programming interface and the encoder; otherwise, if you press
NO, the configuration parameters are updated only in the
programming interface, they are not downloaded to the encoder.
In the Messages section below in the page the
Beware!!! Displayed
parameters could differ from encoder parameters!! message warns of
occurrence and the Load config button starts blinking red.