Datalogic ENC-58 PROG, Instruction Manual, Page: 20 / 38

ENC58 PROG
15
5 - Programming interface
5.1 Configuring the encoder using the software tool
ENC58 programmable incremental encoder is supplied with a
software expressly developed and released by Datalogic Automation
in order to easily programme and configure the device. It allows the
operator to set the working parameters of the device and monitor
whether the device is running properly. The program is supplied for
free and can be installed in any PC fitted with a Windows operating
system (Windows XP or later).
The name of the program executable file is
ENC58_Rx_x_Datalogic_ENGLISH.exe
where Rx_x is the release
version of the file.
The program is available for download at the following address
www.datalogic.com.
It is designed to be installed simply by copying the executable file to
the desired location and there is no installation process.
To launch it just double-click the file icon.
To close the program press the EXIT button in the title bar.
WARNING
Please be aware that the following compatibilities between the
hardware- software version of the device and the software version of
the executable file have to be respected compulsorily.
Compatibility HW-SW EXE FILE
1-1 Up to ...
NOTE
Before starting the program and establishing a communication with
the device, it is necessary to connect it to the personal computer.
The interface is a I 2C (Inter Integrated Circuit) serial interface. To
communicate with the encoder, you must connect the device to the
personal computer through a USB port using the specific connection
cable order code KIT ENC58 supplied by Datalogic.
For any further information please refer to the section “ 4.12 I2C
(Inter Integrated Circuit) serial connection” on page 13.
WARNING
Please make sure that only one encoder is connected to the KIT
ENC58 when you activate the USB connection !