Datalogic ENC-58 PROG, Instruction Manual, Page: 22 / 38

ENC58 PROG
17
The main page of the configuration interface will appear. It consists
of a single page where all parameters and the complete diagnostic
information concerning the connected encoder are available.
Three sections can be found in the page:
1. a top left section where the parameters to program the encoder
can be found;
2. a top right section where the complete diagnostic information
(diagnostic LEDs) can be found; furthermore the following buttons
are available in this section: the DISCONNECTED / CONNECTED
button which is used to activate / deactivate the connection
between the PC and the encoder; two buttons needful to load from
a file (Load config) and save to a file (Save config) the encoder
configuration; the Write EEPROM button which has to be pressed
to save the configuration data on the EEPROM permanently;
3. the Messages section in the bottom of the page where some
information on the sent commands is shown; to delete the list of
the messages press the CLEAR button on the left of the panel.
To establish a communication connection between the PC and the
encoder press the DISCONNECTED button in the top centre of the
page.