Copyright © 2008 – 2019 DARE!! International
Page 38
6.
RadiSense remote control and error codes
6.1
General
The RadiSense
can be controlled remotely through the interfaces of the RadiCentre. The exact
communication protocol, including the specific commands for the RadiSense probe and a listing of
all error codes can be found in the RadiCentre
manual.
Please note that every command must be terminated with a carriage return (CR).
Example RadiCentre 2 / 7:
To get a reading from the RadiSense card in slot 1, using the RadiCentre
serial port or the GPIB
port, the following command can be sent:
“1:D5“
To get a reading from the RadiSense card in slot 4, using the RadiCentre
serial port or the GPIB
port, the following command can be sent:
“4:D5“
Example RadiCentre
1:
To get a reading from the RadiSense card in a single slot RadiCentre, using the RS232 port or USB
port, the following command can be sent:
“D5“
