Copyright © 2008 – 2019 DARE!! International
Page 17
5.
Connect the plug-in card to the desired device(s).
Place the RadiSense E-field sensor where the field strength is to be measured.
Clean the ends of the fibres and connect the cables to both the sensor and the
plug-in card. Make sure the latching pin (notch) of the FC and ST connector fits
correctly in the slot of the chassis connector (in line coupling).
6.
Connect the RadiCentre
system to your PC using any of the available interfaces of
the RadiCentre
system; USB, Ethernet or IEEE-488 (optional).
7.
Place the interlock plug into the interlock connector of the RadiCentre.
The hardware installation for the plug-in card is now complete. The user can control the plug-in
card either through the touchscreen on the RadiCentre
system (only available for the 2 and 7-slot
versions), or by using the control commands in combination with an external software package
such as the RadiMation EMC test software.
3.2
LASER code
As a safety precaution, products that use a LASER can only be turned on using a LASER Code. This
code can be entered into the system by use of the touchscreen of the RadiCentre.
(This safety feature is linked to the RadiCentre 2- and 7-slot version. The LASER activation and safety
is implemented differently in the RadiCentre Single, see chapter 2.5)
To meet the LASER safety precaution, enter the LASER Code in the ‘LASER Code’ screen and press
‘OK’ for confirmation.
