Page 19 of 30
Mark the position on the desk for mounting. Use screws the fix the bracket
securely.
Fit the spigot on the end of the light arm into the top of the clamp, make
sure it is fully secured in place.
Apply the power cable, and power the light on. See page 9.
4.4 Mobile version (X740LM)
See instructional sheet for mobile base.
Remove the light from its packaging.
Place the castor base on firm ground and insert
the upstand into the hold located in the centre.
Placing hands on the top of the upstand, push
down with a firm pressure until the upstand is
fully inserted.
NOTE: Insertion of upstand may be very tight,
and may require the use of a wooden or rubber
mallet to tap the upstand downward.
Rest the mobile base on its side. Push the bolt
through the washer and weight plate. Align the
bolt with the threaded hole in the bottom of the
upstand, insert bolt and turn in a clockwise
direction until tight.
WARNING: Do NOT over tighten the bolt
Once fitted, the upstand will not be able to be
removed from the castor base.
Insert the light-arm's spigot into the top of the
upstand and tighten the knob to secure it in place.
WARNING: DO NOT LIFT THE LIGHT BY THE
ARM AS THIS CAN CAUSE DAMAGE
