Page 15 of 30
4.1.3 X740LE1 – Placement and Installation
Remove the light from its packaging.
This version includes our PIVOTW3 BESA mounting bracket, for mounting to a
BESA box.
Ensure the BESA back-box is mounted between recommended 850-
1100mm from the floor to the underside of the bracket – dependent on
couch height. Ideally, the underside of the bracket should be 150-
200mm above the couch
.
A separate transformer is supplied.
Run low voltage cable (not supplied) between the BESA, through trunking,
to the transformer location.
Fit light into PIVOTW3 and make electrical connection, observing polarity.
Fix the PIVOTW3 bracket to the BESA box (screws not supplied). Ensure a
secure fit.
Power the transformer and test the light.
4.1.4 X740LE2 – Placement and Installation
Remove the light from its packaging.
This version includes our PIVOTW4 spreader plate wall mounting bracket.
Suitable for fixing to all wall types, including brickwork. A separate power
supply is included.
Mark on the wall the selected location for the wall mounting bracket,
bearing in mind the final position of the light head required to project its
light patch where it will be needed.
We recommend 850-1100mm from the floor to the underside of the
bracket – dependent on couch height. Ideally, the underside of the
bracket should be 150-200mm above the couch.
Taking note of the considerations in section 4.1.1, mount the PIVOTW4 wall
bracket directly to the wall. Use a spirit level to ensure the bracket is on a
true vertical plane.
Once the bracket is installed, turn the thumbscrew anti-clockwise to allow a
clear path through the hole.
Slide the light spigot directly into the hole in the bracket. First, make sure
to thread the cable through the Make sure the light is fully pushed in.
Tighten the thumbscrew to secure the light in position.